SinceVision has introduced the SGI-N030W, a wide-spot laser displacement sensor intended for high-speed, non-contact dimensional measurement on rough, textured and irregular surfaces. The company says the sensor extends its SGI Series and is aimed at lithium-ion battery manufacturing, semiconductor processing and precision mechanical engineering, where micrometre-level measurement is required.
According to SinceVision, the design uses an expanded laser spot and optical triangulation to reduce measurement instability that conventional point-spot laser systems can encounter when surface finishes vary. In a point-spot system, reflected laser energy is concentrated on a small area, so microscopic scratches, grain boundaries, brushed textures and matte finishes can introduce signal variations that are interpreted as dimensional changes. SinceVision says this can lead to false defect warnings and additional inspection.
Wide-spot averaging
The SGI-N030W collects reflected light across a broader surface area, averaging localised microscopic peaks and valleys before signal conversion, according to the company. SinceVision says this reduces the influence of surface roughness and optical scattering, and is intended to provide more stable displacement measurements on materials such as drawn metals, sandblasted surfaces and coated battery foils.
Measurement specifications
The sensor has a reference distance of 30 mm and a measurement range of ±5 mm. SinceVision specifies repeatability of 0.05 µm when measuring a diffuse white target under static conditions, with linearity of ±0.02% of full scale across the range. Sampling frequency is 50 kHz, equivalent to a 20 µs update interval, for high-speed measurement and monitoring of dynamic processes.
Communication options include RS485, 100Base-TX Ethernet and switchable analogue outputs for 4–20 mA current or 0–10 V voltage signals. The system also supports master-slave synchronisation, allowing two sensors to operate in opposition and measure from either side of a component or moving material.
Battery electrode thickness
One main application identified by SinceVision is in-line thickness measurement of lithium-ion battery electrodes. Coating thickness and uniformity affect energy density, internal resistance and long-term cell stability, the company notes. Conventional offline inspection with contact micrometers or drop indicators can introduce operator variability and may deform wet or uncured electrode materials, while periodic spot measurements cannot provide continuous coverage across a production reel.
The proposed arrangement uses two synchronised sensors above and below a moving electrode web, mounted on a calibrated, low-thermal-expansion marble gantry. The opposing heads measure their respective clearances to the material, and a controller combines those readings with the fixed mounting datum to calculate absolute electrode thickness in real time. SinceVision reports that production trials demonstrated stable, repeatable thickness measurement within ±0.3 µm at a web speed of 300 mm/s. The 50 kHz sampling frequency is intended to provide high longitudinal resolution for detecting localised coating agglomerations, edge thinning and exposed substrate before the material reaches cell winding.
Semiconductor and assembly applications
The SGI-N030W is also intended for semiconductor manufacturing, where non-contact measurement is important for sensitive wafer surfaces. Potential uses cited by SinceVision include wafer position verification, edge detection, height measurement and checks of wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems. In precision assembly, the sensor can monitor voice coil motors, linear actuators and micro-steppers, capturing transient displacement, mechanical oscillations, settling behaviour and end-stop overshoot across the full range. Position data can be sent to machine control systems through the Ethernet interface.
Surface-related errors
Jack Li, SinceVision’s global sales and marketing director, says false defect warnings caused by surface texture remain a recurring challenge in battery manufacturing and precision assembly. He explains that conventional point-beam laser sensors can interpret microscopic scratches and rough coatings as actual thickness variations, slowing production lines and creating a need for manual inspection. According to Li, the SGI-N030W’s expanded optical spot is designed to average out these surface-related variations, while synchronisation between opposing sensor heads supports high-speed thickness verification.
