Automotive Accessories

Builder Creates Budget Rear Portal Axle by Flipping a Jeep Differential

Rafael LindqvistNovember 17, 20265 min read1 views

At a glance

  • Zeph Gage combines a Ford 9-inch housing, Humvee geared hubs, and custom adapters to add rear clearance to an XJ Jeep at about one-fifth the cost of typical portal axles.
  • Zeph Gage has built a rear-only portal axle for an XJ Jeep by flipping the differential and combining a Ford 9-inch housing with Humvee geared hubs and adapters. The setup aims to add about six inches of clearance while preserving shock travel and avoiding the packaging constraints of a full portal conversion.
A conceptual cutaway illustration of a rear-only portal-axle conversion, showing a flipped differential, geared wheel hubs and custom brackets on a modified off-road vehicle.

Portal axles are prized by hardcore off-roaders because they raise a vehicle and improve obstacle clearance, but a typical set costs about $20,000. Zeph Gage has developed a rear-only alternative for his XJ Jeep that costs roughly one-fifth as much.

Portal axles use a stack of gears behind each driven wheel instead of letting shafts and other hardware hang below the transmission and transfer case. That arrangement allows the axle shafts to sit higher, leaving less hardware below the frame and creating room for taller tires and greater ground clearance.

Gage's conversion combines a Ford 9-inch axle housing, geared hubs from a Humvee, and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals such as the Humvee units reverse the rotation of the input shaft. To correct that with the Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the proper direction. A Yukon Gear and Axle third member is then bolted to the differential, turning low-pinion parts into what amounts to a budget high-pinion arrangement.

The setup adds about six inches of clearance while retaining full shock travel, a combination that can be difficult with portal axles. Gage also expects the arrangement to reduce stress on the differential and to be effectively bulletproof.

Installing a portal only at the rear is a common trick in the remote-control rock crawler scene. By keeping the solid axle up front, Gage avoids the packaging constraints that often arise when portal axles are fitted to a vehicle that never had them from the factory. He also avoids restricting shock travel because of those constraints, and the ride height does not rise to an excessive level. The result is a best-of-both-worlds arrangement.

This is not an off-the-shelf solution. Gage did extensive custom fabrication, including homemade brackets, custom-tapped plates, and a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric emergency-brake solenoid and helps with clearance.

The resulting XJ Jeep can drive over a five-gallon bucket and still have several inches of spare clearance. That means the rear end should not get hung up on obstacles that the front end can steer around. Gage also had to match gearing front and rear. The rear-only design leaves the front axle without the added clearance of a full portal conversion, but it targets the rear axle's tendency to catch on obstacles.

Reported by Rafael Lindqvist, Vehicle Lighting and Vision Electronics Editor.